- Bolt conveyor together
- Weld 6" on each corner of the splice where angles
bolt together.
(This is recommended on anything longer than 125')
- Set axle up on blocks with radial position facing
toward the head section
(Only if it is a 4 tire axle or smaller)
- Pin the bottom of the telescope leg and the dead
section leg to axle.
- Lift conveyor up over axle
- Pin the top of the telescope leg to the head section
and pin the top of the dead section leg to the tail end
of the truss.
- Make sure the axle is level.
- Set the conveyor to desired incline and pin
the stacker at that height.
- Connect the bushing end of the stabilizing bars to
the axle. The other end has to be made to fit.
(You will cut to length and then pin it to the dead leg.)
- Note: Do not rest the stacker on uprights on axle, and
always unhook the stabilizing bars when adjusting the
stacker up or down.
|
